Circling the Square

Board with Bluetooth LE 4

With the version of Lightlog supporting Bluetooth LE 4.0 (BLE), I took on the challenge of laying out the board to fit inside a circle. From the very early prototypes I’ve wanted Lightlog to be circular, but at that stage it was just not practical. Fewer sharp corners is always helpful when it is on something you need to wear, the round shape is also amenable to a wider range of enclosure designs.

The circular board ‘almost’ fits within the rectangle of the previous SMT layout size, but it feels noticeably smaller as its area is much less without the corners. Below is an image of the current circular board layout, a full set of Gerber files can be found over on the Lightlog git repository. There are some power management related changes needed for the next board revision – I’ll try to write a separate blog post on this – but this board is getting close…

LightLog_SMD_0.7_Rev_A